Views: 16 Author: Site Editor Publish Time: 2023-05-31 Origin: Site
What are the installation steps for EIR SPC flooring? This is a problem for many homeowners, EIR SPC flooring if not installed well, will bring many adverse effects on home life. The following will introduce you to the EIR SPC flooring installation steps, very practical. I hope it can help you.
Installation of transition buckle
Laying moisture-proof floor mat
Start laying the wooden floor
Pay attention to the gap and interface size
Keep it horizontal
Pay attention to the angle of the wooden floor
Indoor paving EIR SPC flooring, generally more than one room. So before paving, you should install transition strips in the room or the aisle, leaving a gap of 10 mm for some fixed objects and walls. As an example, the longest wall of the room is 10 meters, the maximum area is 100 square meters, then the gap reserved by the wall is calculated according to the length of the wall, and 1.5 mm per meter is reserved. This gap is to take into account the expansion and contraction of EIR SPC flooring.
EIR SPC flooring is usually laid using the suspension method. That is after the ground is leveled and cleaned up, you should first lay a layer of moisture-proof floor mats on the ground, and then directly on the moisture-proof floor mats to lay EIR SPC flooring. it should be noted that this layer should be at least from the wall to leave a gap of about 20-30 cm. Damp-proof floor mat as long as you need to lay roughly 5-10 rows of flooring.
EIR SPC flooring front X - tongue and groove towards the wall, from the left corner to the right to start laying. Because EIR SPC flooring is a locking structure, the tongue and groove can be used without glue. At this point, you do not have to worry about the glue containing formaldehyde and other ingredients to indoor pollution problems. This process is simple, so the speed of paving is. One of the biggest benefits of using the suspension laying method is that EIR SPC flooring suspended floor splicing. It is easy to repair and replace wooden floors when they are off-seam or locally damaged.
Make sure to leave a gap of approximately 10 mm between the EIR SPC flooring and the wall when laying. To prevent the first row of wooden flooring from sliding, be sure to secure it with spacers or wedges. Usually, the remaining flooring in the first row is the beginning of the second row. Be sure that the interface of the second row of EIR SPC flooring is staggered with the interface of the first row of flooring by at least 30 cm.
One EIR SPC flooring is inserted into the recess of the previous one, it is necessary to keep the floor covering in a horizontal state and symmetrical so that the visual effect will be good.
Each next piece of EIR SPC flooring should be following the angle of the paved wooden flooring, to ensure that the longer side of the wooden flooring and the previous line of wooden flooring are closely together. EIR SPC flooring paving is generally a stepped gap structure, such as the three-sixty-nine paving method and one-half of the paving method, due to the three-sixty-nine paving method to save material, the loss is about 3%. Therefore, this is the most commonly used paving method. And one-half although the visual effect is better, more supplies, higher than about 5%.
EIR SPC flooring has the characteristics of wear resistance, rich pattern, stain resistance, high-cost performance, etc. Shandong Wanli Decoration Materials Co., Ltd reminds you that the usual maintenance should pay attention to maintaining the appropriate humidity in the room, stains should be cleaned in time, and avoid direct sunlight. Only then the service life of EIR SPC flooring will be longer.